The opening range is the high and low of the first stretch of the regular session. Many traders use the first 15 minutes, from 9:30 AM ET to 9:45 AM ET. It gives you two prices that a lot of participants are watching and a natural place to define risk.
A break of the range on its own is close to a coin flip with a wide spread. Reading the bias first gives you a filter before the break happens.
01The setup
- Mark the high and low of the first 15 minutes.
- Read the stack bias on the 5-minute chart once the range is complete.
- Read Compass. A bias that agrees with the higher timeframes carries more weight.
- Note where VWAP sits inside the range.
02The trigger
With a bullish bias, you only care about the top of the range. Look for a 5-minute close above it, on volume that holds up against the bars before it. With a bearish bias, mirror it at the bottom. A break against the bias is a pass, however clean it looks.
03Where the stop goes
The midpoint is the usual invalidation on a wide range. On a narrow range, use the far side. Then check the arithmetic. Take a range of 50.00 to 50.80 and a long on a close at 50.85. A stop at the 50.40 midpoint risks 0.45, so 2R is 51.75. If yesterday's high sits at 51.20, the reward isn't there and the trade comes off the list.
04What to skip
- Ranges that have already used most of the ticker's average daily range.
- Breaks that run straight into yesterday's high or low.
- Any session where the stack reads no clear bias at the end of the range.
05Reviewing it
Label these trades the same way every time in the trade journal. After 30 of them, compare the ones taken with the bias against the ones taken without it. That one comparison tells you whether the filter is earning its place.